Skoda Octavia Workshop Manual (S00.5111.50.20 Edition 08.96) 1.9-ltr. / 66 kW (TDI) Engine Fuel Injection and Glow Plug System

Skoda Octavia Workshop Manual (S00.5111.50.20 Edition 08.96) 1.9-ltr. 66 kW (TDI) Engine Fuel Injection and Glow Plug System PDF free online

CONTENTS

01 Self-Diagnosis

  • Self-Diagnosis
    • Properties of the self-diagnosis
    • Technical data of self-diagnosis
    • Connecting tester V.A.G 1552 and select engine electronics control unit
    • Interrogating and erasing fault memory
    • Fault table
  • Actuator diagnosis
    • Performing actuator diagnosis
    • Basic setting
    • Coding control unit
  • Readiness code
    • Reading readiness code
    • Generate readiness code
  • Measured value blocks
    • Reading measured value block
    • Display nominal values for general vehicle inspection
    • Display nominal values for injection pump
    • Display nominal values for engine idling
    • Display nominal values for exhaust gas recirculation
    • Display nominal values for temperature sensor
    • Display nominal values for automotive power
    • Display nominal values for charge pressure control

23 Fuel Formation/Injection

  • Servicing a diesel direct fuel injection system
    • Safety measures
    • Rules for cleanliness
    • Overview of fitting locations > 07.97
    • Overview of fitting locations 08.97 > 07.00
    • Overview of fitting locations 08.00 >
    • Assembly overview of injection pump
    • Assembly overview of fuel filter
    • Assembly overview of throttle mechanism
    • Adjusting sender for accelerator pedal position
    • Disassembling and assembling air filter
    • Removing and installing injection pump
    • Dynamically testing and setting commencement of injection
    • Removing and installing and testing injection nozzles
    • Wiring and Component Test with Test Box
    • Replacing engine control unit
  • Inspecting the charge air pressure system
    • Inspecting charge air pressure
    • Inspecting charge pressure control solenoid valve (N75)
    • Inspecting intake manifold temperature sender (G72)
    • Inspecting intake manifold pressure sender (G71) and altitude sender
    • Hose layout plan for charge pressure control
  • Testing injection control
    • Testing injection timing device control range
    • Testing the commencement of injection valve (N108)
    • Inspecting fuel temperature sender
  • Inspecting exhaust gas recirculation system
    • Inspecting exhaust gas recirculation
    • Inspecting exhaust gas recirculation valve (N18)
    • Inspecting air mass meter (G70)
    • Vacuum plan of hose layout plan for the exhaust gas recirculation system
  • Inspecting control units input quantities
    • Testing voltage supply for diesel direct injection system
    • Testing engine speed sender (G28)
    • Testing needle lift sender (G80)
    • Testing coolant temperature sender (G62)
    • Testing brake light switch and brake pedal switch
    • Testing modulating piston movement sender (G149) and metering adjuster (N146)
    • Testing accelerator pedal position sender (G79)
  • Testing auxiliary signals
    • Testing signals from/to the air conditioning system
    • Testing clutch pedal switch (F36)
    • Testing speed signal
    • Testing engine speed signal
    • Activating or deactivating cruise control system
    • Testing cruise control system
    • Testing CAN-Bus databus
  • Servicing intake manifold 08.97 >
    • Inspecting the change-over of the intake manifold flap
    • Hose layout plan for intake manifold flap operation

28 Glow plug system

  • Inspecting glow plug system
    • Inspecting proper operation
    • Inspecting glow plugs
    • Inspecting glow period warning lamp

Language: English
Format: PDF
Pages: 194

Skoda Octavia Workshop Manual (S00.5111.50.20 Edition 08.96) 1.9-ltr. 66 kW (TDI) Engine Fuel Injection and Glow Plug System PDF free online

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More