Skoda Octavia Workshop Manual 1.9L 66kW TDI Engine Fuel Injection and Glow Plug System
Skoda Octavia Workshop Manual 1.9L 66 kW (TDI) Engine Fuel Injection and Glow Plug System PDF
CONTENTS
Self-Diagnosis
- Self-Diagnosis
- Properties of the self-diagnosis
- Technical data of self-diagnosis
- Connecting tester V.A.G 1552 and select engine electronics control unit
- Interrogating and erasing fault memory
- Fault table
- Fault table
- Performing actuator diagnosis
- Basic setting
- Coding control unit
- Readiness code
- Reading readiness code
- Generate readiness code
- Measured value blocks
- Reading measured value block
- Display nominal values for general vehicle inspection
- Display nominal values for injection pump
- Display nominal values for engine idling
- Display nominal values for exhaust gas recirculation
- Display nominal values for temperature sensor
- Display nominal values for automotive power
- Display nominal values for charge pressure control
Fuel Formation/ Injection
- Servicing a diesel direct fuel injection system
- Safety measures
- Rules for cleanliness
- Overview of fitting locations >- 07.97
- Overview of fitting locations 08.97 >- 07.00
- Overview of fitting locations 08.00 >-
- Assembly overview of injection pump
- Assembly overview of fuel filter
- Assembly overview of throttle mechanism
- Adjusting sender for accelerator pedal position
- Disassembling and assembling air filter
- Removing and installing injection pump
- Dynamically testing and setting commencement of injection
- Removing and installing and testing injection nozzles
- Wiring and Component Test with Test Box
- Replacing engine control unit
- Inspecting the charge air pressure system
- Inspecting charge air pressure
- Inspecting charge pressure control solenoid valve (N75)
- Inspecting intake manifold temperature sender (G72)
- Inspecting intake manifold pressure sender (G71) and altitude sender
- Hose layout plan for charge pressure control
- Testing injection control
- Testing injection timing device control range
- Testing the commencement of injection valve (N108)
- Inspecting fuel temperature sender
- Inspecting exhaust gas recirculation system
- Inspecting exhaust gas recirculation
- Inspecting exhaust gas recirculation valve (N18)
- Inspecting air mass meter (G70)
- Vacuum plan of hose layout plan for the exhaust gas recirculation system
- Inspecting control units input quantities
- Testing voltage supply for diesel direct injection system
- Testing engine speed sender (G28)
- Testing needle lift sender (G80)
- Testing coolant temperature sender (G62)
- Testing brake light switch and brake pedal switch
- Testing modulating piston movement sender (G149) and metering adjuster (N146)
- Testing accelerator pedal position sender (G79)
- Testing auxiliary signals
- Testing signals from/to the air conditioning system
- Testing clutch pedal switch (F36)
- Testing speed signal
- Testing engine speed signal
- Activating or deactivating cruise control system
- Testing cruise control system
- Testing CAN-Bus databus
- Servicing intake manifold 08.97
- Inspecting the change-over of the intake manifold flap
- Hose layout plan for intake manifold flap operation
Glow plug system
- Inspecting glow plug system
- Inspecting proper operation
- Inspecting glow plugs
- Inspecting glow period warning lamp
Language: English
Format: PDF
Pages: 194