Skoda Octavia Workshop 1.4L 55kW Engine, Motronic Fuel Injection and Ignition System
Skoda Octavia Workshop 1.4-ltr./55 kW Engine, Motronic Fuel Injection and Ignition System PDF.
CONTENTS
01 Self-diagnosis
- General information about the self-diagnosis
- Properties
- Technical data for the self-diagnosis
- Connecting up the vehicle system tester V.A.G 1552 and selecting the address word for the engine electronics
- Interrogating and deleting the fault memory
- The fault table
- Actuator diagnosis
- The readiness code
- Reading the readiness code
- Generating the readiness code
- Reading measured value blocks
- Reading measured value blocks, display group 001 …009
- Reading measured value blocks, display group 010…029
- Reading measured value blocks, display group 030…049, 099 – lambda regulation
- Reading measured value blocks, display group 050…069
- Reading measured value blocks, display group 070…079
- Reading measured value blocks, display group 100
24 Fuel preparation/injection
- Repairing the fuel injection system
- General comments
- Safety measures
- Cleanliness regulations
- Installed location of the individual parts of an engine with engine identification characters AXP
- Installed location of the individual parts of an engine with engine identification characters BCA
- Removing and installing parts of the fuel injection system
- Disassembling and assembling intake manifold
- Disassembling and assembling the fuel distributor with fuel injection valves
- Disassembling and assembling the air filter
- Checking components
- Checking the lines using test box V.A.G 1598/22
- Checking the throttle valve control unit (J338)
- Testing jet formation and tightness of the injection nozzles
- Checking the fuel pressure regulator and holding pressure
- Checking the intake system for leaks (unmetered air)
- Checking the intake air pre-warming system
- Checking functionality
- Checking the lambda probe and lambda regulation before the catalytic converter
- Checking the lambda probe and lambda regulation after the catalytic converter
- Engine control unit
- Checking the power supply to the engine control unit
- Procedure if the voltage supply is interrupted
- Replacing the engine control unit
- Coding the engine control unit
- Adjusting the engine control unit to the throttle valve control unit
- Checking auxiliary signals
- Checking the speed signal
- Checking the databus (CAN bus)
28 The ignition system
- Repairing the ignition system
- General comments about the ignition system
- Safety measures
- Removing and installing parts of the ignition system for engines with engine identification characters AXP
- Removing and installing parts of the ignition system for engines with engine identification characters BCA
- Checking components and functions
- Checking the hall sender (G40)
Language: English
Format: PDF
Pages: 118