Technical information should always be available to the foremen and mechanics, because their careful and constant adherence to the instructions is essential to ensure vehicle road-worthiness and safety. In addition, the normal basic safety precautions for working on motor vehicles must, as a matter of course, be observed.
Edition 07.2014
Repair Group
- 00 – Technical data
- 30 – Clutch
- 34 – Controls, housing
- 35 – Gears, shafts
- 39 – Final drive – differential
CONTENTS
- 00 – Technical data
- 1 Identification
- 1.1 Identification of the gearbox
- 1.2 Identification characters, aggregate assignment, ratios, filling capacities (Octavia II)
- 1.3 Identification characters, aggregate assignment, ratios, filling capacities (Octavia III)
- 1.4 Identification characters, aggregate assignment, ratios, filling capacities (Superb II)
- 1.5 Identification characters, aggregate assignment, ratios, filling capacities (Yeti)
- 2 Overview of Transmission System
- 2.1 Designation of components and transmission ratio
- 3 General repair information
- 3.1 Notes
- 3.2 Contact corrosion
- 3.3 Safety measures for working on vehicles with start/stop system
- 3.4 Safety precautions during road tests in which testing and measuring equipment is used
- 3.5 Components
- 1 Identification
- 30 – Clutch
- 1 Clutch control
- 2 Repairing clutch control
- 3 Repairing clutch
- 34 – Controls, housing
- 1 Shift mechanism
- 2 Removing and installing the gearbox
- 3 Check gear oil level
- 4 Disassembling and assembling the gearbox
- 5 Repairing gearbox housing and clutch housing
- 6 Repairing the shift mechanism on the gearbox
- 7 Disassembling and assembling the gearshift forks
- 35 – Gears, shafts
- 1 Drive shaft
- 1.1 Disassembling and assembling the drive shaft
- 1.2 Setting drive shaft
- 2 Output shaft
- 2.1 Disassembling and assembling the output shaft
- 2.2 Setting output shaft
- 3 Reverse shaft
- 3.1 Disassembling and assembling the reverse shaft
- 1 Drive shaft
- 39 – Final drive – differential
- 1 Replacing gasket rings for flange shafts with gearbox installed
- 1.1 Replacing the left flange shaft gasket ring
- 1.2 Difference between the gasket rings with right flange
- 1.3 Replace gasket ring in separated version for right flange shaft
- 1.4 Replace gasket ring in single version (together with bushing) for right flange shaft
- 2 Differential gear
- 2.1 Disassembling and assembling differential gear
- 2.2 Adjusting the differential gear
- 3 Setting overview
- 1 Replacing gasket rings for flange shafts with gearbox installed
Language: English
Format: PDF
Pages: 262