Skoda Octavia 1997 Workshop (S00.5128.50.20) 2.0L 85kW Engine, Fuel Injection and Ignition System
Skoda Octavia 1997 Workshop (S00.5128.50.20) 2.0L / 85 kW Engine, Fuel Injection and Ignition System PDF. Engine code: AEG, APK, AQY, AZH, AZJ
CONTENTS
- 01 – Self-diagnosis
- Self-diagnosis I
- – Properties of the self-diagnosis
- – Technical data of self-diagnosis
- – Connecting vehicle system tester -V.A.G 1552- and selecting the control unit for engine electronics
- – Interrogating and erasing fault memory
- Self-diagnosis II
- – Fault table, fault codes 16485…17736
- Self-diagnosis III
- – Fault table, fault codes 17743…18101
- Self-diagnosis IV
- – Actuator diagnosis
- – Readiness code
- – Reading readiness code
- – Generating readiness code
- Self-diagnosis V
- – Reading measured value blocks, display groups 000 to 029
- Self-diagnosis VI
- – Reading measured value block, display groups 030 to 062
- Self-diagnosis VII
- – Reading measured value blocks, display groups 066 to 126
- Self-diagnosis I
- 24 – Fuel Formation, Injection
- Repairing the injection system
- – General Instructions
- – Safety instructions
- – Rules of cleanliness
- – Individual components of system – Installation overview
- – Removing and installing parts of the injection system
- – Disassembling and assembling the air filter
- – Disassembling and assembling bottom part of intake manifold
- – Disassembling and assembling top part of intake manifold
- – Disassembling and assembling fuel distributor with injectors
- Testing components
- – Testing cables with test box -V.A.G 1598/22- or -V.A.G 1598/31-
- – Testing throttle valve control unit -J338-
- – Testing accelerator pedal position sender
- – Testing injected quantity and injectors for leaks
- – Testing fuel pressure regulator and holding pressure
- Check for proper operation
- – Testing lambda probe -G39- and lambda control upstream of catalytic converter
- – Testing lambda probe ageing upstream of catalytic converter -G39-
- – Testing lambda probe -G130- and lambda control downstream of catalytic converter
- Engine control unit
- – Testing voltage supply for engine control unit
- – Procedure if voltage supply interrupted
- – Replacing engine control unit
- – Code the engine control unit (AEG, APK, AQY)
- – Deleting learned values from the engine control unit
- – Adjusting the engine control unit to the throttle valve control unit
- – Adjusting the kick-down function
- Testing auxiliary signals
- – Testing the speed signal
- – Testing databus (CAN bus)
- – Activating and deactivating cruise control system (CCS)
- Repairing the injection system
- 28 – Ignition System
- Repairing the ignition system
- – General notes on the ignition system
- – Safety measures
- – Removing and installing parts of the ignition system
- – Testing camshaft position sensor -G40-
- Repairing the ignition system
Language: English
Format: PDF
Pages: 118