F3A21 F3A22 F4A21 F4A22 F4A23 Service Repair Manual

GENERAL INFORMATION
Precautions to be taken when disassembling and reassembling the transmission
Because the automatic transmission is composed of component parts of an especially high degree of precision, these parts should be very carefully handled during disassembly and assembly so as not to scar or scratch them.
A rubber mat should be placed on the workbench, and it should always be kept clean.
During disassembly, cloth gloves or shop towels should not be used. If such items must be used, either use articles made of nylon, or use paper towels.
All disassembled parts must be thoroughly cleaned.
Metal parts may be cleaned with ordinary detergents, but must be thoroughly air dried.
Clean the clutch disc, resin thrust plate and rubber parts by using ATF (automatic transmission fluid), being very careful that dust, dirt, etc. do not adhere to them.
Do not reuse gaskets, oil seals, or rubber parts.
Replace such parts with new ones at every reassembly. The О-ring of the oil level gauge need not be replaced.
Do not use grease other than petrolatum jelly.
Apply ATF to friction components, rotating parts, and sliding parts before installation.
A new clutch disc should be immersed in ATF for at least two hours before installation.
Do not apply sealer or adhesive to gaskets.
When a bushing must be replaced, replace the assembly in which it is incorporated.
If the transmission main unit is damaged, also disassemble and clean the cooler system.

CONTENTS

  • GENERAL INFORMATION
  • SPECIFICATIONS
    • TRANSMISSION MODEL TABLE
    • GEAR RATIO TABLE
    • SERVICE SPECIFICATIONS
    • VALVE BODY SPRING IDENTIFICATION (3-SPEED MODEL)
    • VALVE BODY SPRING IDENTIFICATION (4-SPEED MODEL)
    • ADJUSTING PRESSURE PLATE, SNAP RINGS AND SPACERS
    • TORQUE SPECIFICATIONS
  • SPECIAL TOOLS
  • TRANSMISSION (3-SPEED MODEL)
  • TRANSMISSION (4-SPEED MODEL)
  • OIL PUMP
  • FRONT CLUTCH
  • REAR CLUTCH
  • END CLUTCH (4-SPEED MODEL)
  • PLANETARY GEAR
  • ANNULUS GEAR AND TRANSFER DRIVE GEAR SET
  • TRANSFER SHAFT/GOVERNOR (3-SPEED MODEL)
  • TRANSFER SHAFT/TRANSFER DRIVEN GEAR (4-SPEED MODEL)
  • DIFFERENTIAL
  • VALVE BODY (3-SPEED MODEL)
  • VALVE BODY (4-SPEED MODEL)
  • KICKDOWN SERVO
  • LOW-REVERSE BRAKE
  • SPEEDOMETER GEAR
  • DRIVE SHAFT OIL SEAL

Language: English
Format: PDF
Pages: 146

F3A21 F3A22 F4A21 F4A22 F4A23 Service Repair Manual